TUMA11: Using PA Biasing Controllers to Reduce Bias Circuit Complexity
IMS2026
RF PAs require precision biasing on either their drain or gate to optimize performance, efficiency, and reliability. A large amount of engineering manpower and board space goes into designing the bias...
TUMA12: AI-Assisted Workflows for Passive Component Design
IMS2026
Artificial intelligence is reshaping passive component design particularly for RF filter components. Conventional workflows depend on experience and extensive prototyping, which increases cost, slows ...
TUMA13: 5G Radio Power Saving Techniques with TI RF Transceivers: RF Planning, System-Level Techniques, and Device Features
IMS2026
With driven demand for wireless data, radio operators combat rising global energy costs and inherent higher power consumption of 5G radios with radio power efficiency mechanisms and techniques. This m...
TUMA14: A Practical Simulation Approach for RF Desense Mitigation of Consumer Electronics
IMS2026
The Internet of Things (IoT) demand smaller device footprints with greater functionality. As data rates and communication ranges rise, interference between co-located digital and RF systems becomes a ...
TUMA15: Advanced Stability in RF Design
IMS2026
Learn about the new stability enhancements in the Spectre X 25.1 simulator, which include the following new features for RFIC designers: 1) Improved stability accuracy in the presence of strong feedba...
TUMA16: About Sampling Rates, Master Clock Rates, and Nyquist Zones on the USRP X440
IMS2026
Recent advances in ADC and DAC technology have enabled the practical realization of direct-sampling architectures, which provide access to the full RF bandwidth provided by the ADC/DAC. However, there...
TUMA17: Co-Site Interference – The Efficient Simulations in WIPL-D Software
IMS2026
Integrating multiple electromagnetic systems on modern platforms creates severe co-site interference, difficult to measure or simulate, especially at high frequencies where platforms are electrically ...
TUMA18: Impact of reference clock slew rate on RF synthesizer phase noise and improvement techniques
IMS2026
Phase Locked Loops(PLLs), also known as RF synthesizers are used for generating high frequency outputs phase locked to low frequency references across various bands for example L to Ka band. Output ph...
TUMA19: Optimization of Heat Pipe Configuration in an Air-Cooled Aluminum Heat Sink for a Radio Frequency Amplifier
IMS2026
The performance of an RF amplifier air-cooled heat sink is compared for three heat pipe configurations. The heat sink dissipates a total of 1900W split between two drivers (150W, 35.9 W/cm2 each) and ...
TUMA20: Advances In Thermal Analysis to Address the Growing Thermal Challenges of 3D Heterogeneous Integration
IMS2026
An overview of structural, mechanical, and thermal characterization techniques to address the thermal challenges of advanced integrated circuits and 3D heterogeneous packaging including the characteri...